Products

Smart LNB

Next generation Interactive Satellite terminal, the smartLNB is the most integrated and advanced CPE for consumer and IOT services, powered by Ayecka’s RFModem technology and in partnership with Eutelsat. Operates with Eutelsat Smart LNB network, providing transactional random access scheme with exceptional bandwidth utilization compared to any other solution.

It has Ku Reception for TV Signals and Broadcast Data and Ka Transmission for Transactional-Message-based, Random traffic profile for large networks.

The terminal is Low in CAPEX – Terminal cost Lower than VSAT
And Low OPEX – Message at Cellular network cost.
system provides High Network Availability, closed-network with SLA.

Product Pictures

Product Highlights

  • Low Terminal Cost Sub Lower than VSAT
  • Low Service Cost
  • Reuse of existing infrastructure
  • Standard based (DVB-S2 and F-SIM, ESSA)
  • Compliant with legacy DTH services
  • Ka or Ku Transmission
  • Ku Reception

Product Applications

  • Transaction-Orientation
  • Interactive-TV: VoD, Voting, Shopping, Social TV
  • Message-based, Random Access Large-scale networks
  • Lottery, ATM
  • SmartGrid, M2M and SCADA - IoT
  • Cache-Rich, Centric-Based, Internet Access


Short Technical Specifications


Standards DVB-S2 outbound, F-SIM, ESSA inbound
Modulation Outbound: QPSK, 8PSK,16APSK, 32APSK
Inbound: QPSK-spread spectrum
Channel Rate Outbound – up to 45 mbps
Inbound- Up to 1 Mbps (burstable typical 128kbps)
Link Layer F-SIM
Components Antenna, ODU and IDU

Antenna

Antenna size 76Cm
ODU weight <10kg

ODU - RFModem

Transmit Frequency Ka: 29.5 - 30GHz
Ku: 13.75 – 14.5GHz
Receive Frequency 10.7 – 12.75 (dual band)
Connection to IDU F-Type (Ethernet Over Coax)
Tx Output Power Ka: 100mW
Ku: 300mW
LNB Power 13/18V, 22Khz, DiSEqC 2.0
Encapsulation Rx: MPE
TX: RLE
IP Routing Multicast and Unicast
Networking DHCP, NAT

Control and Monitoring

Serial Port Serial over USB CLI
Management via IDU WebGUI
Maintenance Software, Firmware and boot loader are field upgradable using OTA protocol

Environmental Conditions

Operating Temp. -40° to 70° C
Humidity 0% to 100% non-condensing
Rain <100mm/Hr

IDU

Power Supply Power up the ODU via Coax - 12V DC
Interfaces Towards ODU -F-type, Towards STB – F-type
To Home Router (IP Network) – RJ45 (Ethernet)